Impregnation and Preservation

Impregnation of cement tiles is obligatory. Tiles have to be impregnated at least 2 times before usage. You can choose one from the options in category. Glue and joint are specialy made for cement tiles.

Products

The product is ready for immediate use. The agent should be applied and spread evenly with a thin layer using a roller or a wide, soft brush on previously cleaned plate. Oil applied after a two-layer impregnation, in order to strengthen the protection tiles. Please note that you always leave the surface to dry completely for 24 hours.Excess undissolved...

31,58 €

The product is ready for immediate use. The agent should be applied and spread evenly with a thin layer using a roller or a wide, soft brush on previously cleaned plate. Oil applied after a two-layer impregnation, in order to strengthen the protection tiles. Please note that you always leave the surface to dry completely for 24 hours.Excess undissolved...

72,37 €

The product is ready for immediate use. The agent should be applied and spread evenly with a thin layer using a roller or a wide, soft brush on previously cleaned plate. Oil applied after a two-layer impregnation, in order to strengthen the protection tiles. Please note that you always leave the surface to dry completely for 24 hours.Excess undissolved...

72,37 €

Dry mixture put into conatiner with water than mix then tugether untill they blend completly. Put it away for 5 minuts then mix them again. If there is a need add a little of extra water. Be carefull, too much water may cause problems during putting proccess. Final colour will be seen when the mortar will be dry.

15,79 €

The mortar Ceresit CM 17 is used for fixing ceramic tiles, cement and stone (except marble) on deformable substrates. Bond properties provide a flexible connection to the substrate carrying the shear stresses between the plate and the substrate. Therefore CM 17 is recommended for fixing tiles on slender partition walls, heated floors, facades, terraces...

23,68 €

The mortar Ceresit CM 17 is used for fixing ceramic tiles, cement and stone (except marble) on deformable substrates. Bond properties provide a flexible connection to the substrate carrying the shear stresses between the plate and the substrate. Therefore CM 17 is recommended for fixing tiles on slender partition walls, heated floors, facades, terraces...

13,16 €
© 2018 Cerames | All rights reserved | Design by PRESTAPREMIUM